Starting Procedure - Maruyama BL70 Manuel Du Propriétaire/De L'utilisateur

STARTING PROCEDURE

STEP #1)
Pump the "PRIMER BULB" under of the carburetor until
fuel can be seen flowing through the "FUEL-RETURN
LINE".
STEP #2)
Move the "CHOKE LEVER" fully upward to the closed
position. If the engine is already warm, only a partial or open
(no choke) choke setting may be required.
STEP #3)
Set the switch to the state in which "I" is pressed (see sketch).
Set the THROTTLE LEVER at 1/2 speed.
STEP #4)
Press down the " BLOWER HOUSING" and hold the
"FRAME" with your right foot gently.
Pull the "STARTER GRIP" briskly to start the engine.
NOTE: Only short pulls are necessary. Never pull the starter
cord to its fullest extension. Never let go of the starter grip
until it is at the fully returned position.
STARTER
GRIP
If a MARUYAMA engine fails to start after following the above procedures, contact an authorized MARUYAMA dealer.
OPERATING INSTRUCTIONS
STANDARD type
FRAME
CHOKE
LEVER
PRIMER
BULB
FUEL
RETURN LINE
HA type
LEVER
IDLE SPEED
FULL THROTTLE
STEP #5)
Warming up the engine.
When the engine has started, slowly move the
"CHOKE LEVER" fully downward to the open position.
Allow the engine to "WARM-UP" at less than 1/2
speed.
CHOKE
LEVER
English -9
CLOSE
OPEN
FULL THROTTLE
IDLE SPEED
OPEN