Tripp-Lite AG-054D Serie Manuel Du Propriétaire page 11

4. Installation
Cable routing guides are provided in the upper frame of the rack. Route the cable through the openings in for the following
order:
1. Display data cable (DB9 connector)
2. Display power cable (green three-pin connector)
The routing locations are shown with side panel removed in the diagram below:
Rear of LCD display:
1
USB Slave (Not Used)
2
USB Host
(For Service Only)
3
Power Input Terminal
4 1
COM 1
(Used for
2
Display Data
Cable)
5
LAN Port (Not Used)
5
Note: A loop of each cable needs to remain near to the door hinge in order to allow the door to open easily and not stress the cables.
Additional cable can be bundled and secured to attachments on the rear of the door with zipties (not included).
11
3
4