Specific Safety Instructions - EGAmaster 60194 Manuel D'instructions

Battery tool use and care
- Ensure the switch is in the off position before inserting battery pack. Inserting the battery
pack into power tools that have the switch on invites accidents.
- Recharge only with the charger specified by the manufacturer. A charger that is suitable for
one type of battery may create a risk of fire when used with another battery pack.
- Use battery tools only with specifically designated battery packs. Use of any other battery
packs may create a risk of injury and fire.
- When battery pack is not in use, keep it away form other metal objects like paper clips,
coins, keys ,nails, screws, or other small metal objects that can make a connection from one
terminal to another. Shorting the battery terminals may bums or a fire.
- Under abusive conditions, liquid may be ejected from the battery, avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation or bums.
- Do not use the battery/charger alt battery/charger temperatures or ambient temperatures of ≤
5ºC/40ºF or ≥ 40ºC/105ºF.
- Do not dispose defective batteries in the normal domestic waste. Take them to a reputed
waste disposal company.
Service
- Have your power tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.
- Comply with maintenance instructions and instructions on tool replacements.
- Check mains lead of power tool regularly and have it replaced by a qualified expert. Check
extension cable regularly and replace it when damaged.
- Use personal safety equipment.
- Avoid unnatural postures, and do not lean too far forward.
- Before changing the pressing or expanding tools, pull the mains plug or take out the battery.
- The drive units develop a very high pressing force. For that reason, be particulary careful.
Keep all other persons away from the working area during working.
- Hold the drive units only by the housing grip during operation. Keep your hands away from
moving parts (pressing area, expanding area)
- Never operate radial presses when the tongs shank is not locked. Risk of fracture.
- Always position radial presses tongs on the press fitting al right angles to the pipes axis.
Never position it askew.
- Do not start radial presses without pressing tongs inserted. Do not start the pressing
operation except to make a press joint. Unless counter pressure is applied by the press
fitting, the drive unit or pressing tongs will be needlessly stressed.
- Before using pressing tongs from other manufacturers, check that they are suitable for the
drive unit. Consult and comply with the pressing tongs manufacturers' instructions for use.
- Only operate axial presses with the pressing heads fully inserted. Risk of fracture.
- Always position presses with the pressing tongs on the compression sleeve fitting at right
angles to the pipe axis. Never position it askew.
- Screw expanding heads as far they will go onto the expander.
- Do not attempt to repair damaged pressing tongs, pressing heads or expanding heads. Risk
of fracture.
- Consult and comply with the instructions for installation and fitting of the system's
manufacturers.
12

SPECIFIC SAFETY INSTRUCTIONS