RedMax EXZ260S-PH Manuel D'utilisation page 8

1. Press the throttle trigger lockout (A) and make sure
that the throttle control is released (B).
B
Note: When you release the handle the throttle
control and the throttle trigger lockout both move
back to their initial positions. This movement is
controlled by two independent return springs. This
arrangement means that the throttle control is
automatically locked at the idle setting.
2. Make sure that the throttle control is locked at the
idle setting when the throttle trigger lockout is
released.
3. Press the throttle trigger lockout and make sure that
it returns to its intial position when you release it.
4. Do a check of the throttle control and throttle trigger
lockout move freely and that the return springs work
properly.
8
A
5. Start the product (see instructions under
product on page 14 ) and apply full throttle.
6. Release the throttle and make sure that the cutting
attachment stops and remains at a standstill. If the
cutting attachment rotates with the throttle in the idle
position the carburettor idle setting must be checked.
See instructions under the chapter
product on page 15 .
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
To do a check of the cutting attachment guard
WARNING: Do not use a cutting attachment
without an approved and correctly attached
cutting attachment guard. See
on page 21 .
WARNING: Always use the recommended
cutting attachment guard for the cutting
attachment that you use. If an incorrect or
faulty cutting attachment guard is fitted this
can cause serious personal injury. See
intructions under heading
page 20 .
The cutting attachment guard prevents injuries from
objects that eject in the direction of the operator. It also
To start the
To stop the
Accessories
Technical data on
1111 - 002 - 21.03.2019