Hendi Xenon pro Mode D'emploi page 8

Cleaning and maintenance
• The Powergrill has a self cleaning working. There-
fore you have to let the burner burn at it's full power
for approximately 10 minutes. Fat and remains will
then be vaporised or burned.
• Beware: Never immerse the appliance in water or
any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• The grid and/or baking tray should be cleaned reg-
Faults
Fault
burner fails to ignite
at all:
EN
If in doubt, please contact your supplier.
Note
• It is to be recommended to replace the gas hose
after 3 or 4 years (see date shown on hose). The
gas hose becomes porous after a time.
• Consult the local regulations, these may differ.
Assembling the undercarriage
The following parts have been supplied for the assembling of the under-carriage:
- 1 wheel frame
- 1 body frame
- 2 bolts M6x40.
- 2 bolts M6x65.
8
Possible cause
defective ignition
defective thermocouple
dirty spark plug
defective pressure regulator
empty gas cylinder
kink in gas hose
clogged jet
ularly. Use a special barbecue cleaner and follow
the instructions on its packaging.
• Clean the ventilation slots (if applicable) with a vac-
uum cleaner.
• Keep inside after use.
• Let specialised personnel clean the burner at least
once a year.
• Never use a high pressure cleaner.
Fault Possible cause
gas cylinder (almost) empty
kink in gas hose
gas cylinder valve not entirely open
burner does not ignite
completely:
clogged jet
defective valve
• Always store gas bottles upright, even when
empty.
• It is not allowed to modify this appliance, if this is
desired please contact the manufacturer.
- 4 Cap nuts M6.
- 2 rings M6.
- 1 star bolt M6