VOICE GUIDE
The machine is equipped with a voice synthesizer that accompanies the user during use. It is possible select the language when, if it was
not the previous set from the factory, as follows:
when the display shows the desired language, push the knob "MENU".
THE CORRESPONDENCE BETWEEN LANGUAGE AND THE DISPLAY IS AS FOLLOWS:
"IT_" - ITALIAN
"EN_" - ENGLISH
"ES_" - SPANISH (optional)
"RU_" - RUSSIAN (optional)
"De_" - GERMAN (optional)
"FR_" - FRENCH (optional)
RESET (LANGUAGE AND WELDING PARAMETERS)
In case you want to re-select the language and return to factory settings, perform the following steps:
• Turn off the welding machine
• Simultaneously push the knob "MENU" and turn on the welder. The display shows "ooo" in case of success
• Release MENU. The display will scroll the selectable language.
• Select the desired language by pushing "MENU"
AUTO ADJUSTMENT PARAMETERS
The machine is able to self adjust its welding parameters according to the user selection:
selecting the type and diameter of the electrode, changing the value of the welding current, the electrode diameter correlated selection for
the type previously selected.
PROTECTION FROM OVERHEATING
If the machine weld for a hard duty cycle, the thermal protection power on to protect the machine from a probably over heating. When the
device power on, the "LED TERM" is on, (see Figure 2) and the display shows "H00".
INSTALLATION
The installation must be made by trained personnel in compliance to the standard IEC 60974-9 and the current legislation. To lift the
machine must be used the handle positioned on top of the product with the machine in OFF position and the welding cable disconnected.
The input voltage must match the voltage indicated on the technical plate located on the product. Use the machine on a electrical grid
whose the power characteristics and the protection (fuse and / or differential switch) are compatible with the current required to work, for
more details see the information on the nameplate affixed to the machinery.
WELDING
Warning: Use general cautions included in this general manual before attempting to operate the welding machine by reading carefully the
risks associated with the welding process.
All manuals and user guides at all-guides.com
When the voltage supply is greater than 250V, the machine go in protection mode and it not allow to
weld until the voltage supply is not within the allowed limits, the display will show "HI".
8