Description Of The Machine; Control Panel - Stanley GOLDEN ARC MINI Manuel D'utilisation

•
Iniziare l'operazione di saldatura utilizzando tutte le protezioni necessarie alla sicurezza.
•
Completata la saldatura, spegnere la saldatrice e togliere l'elettrodo dalla pinza porta elettrodo.
MANUTENZIONE
Ogni intervento di manutenzione deve essere eseguito da personale qualificato nel rispetto della norma (IEC 60974-4).
La presenza del simbolo indica che la macchina non è munita di pfc.
Assicurarsi con l'installatore e in conformità con IEC 60974-9 che la saldatrice possa essere collegata alla rete pubblica a bassa tensione.

DESCRIPTION OF THE MACHINE

This device is a current inverter generator (DC) suitable for welding electrode MMA. Thanks to the inverter technology which allows to
achieve high performance and low size and weight, the welder is portable and easy to handle. The device is suitable for welding with coated
electrodes (rutile, basic, stainless steel and cast iron ). It is a single phase 230V 50/60Hz and can be connected to power generators having
power equal to or higher than that reported in Table 2.
The machine is equipped with the following functions:
• "MAINS ANALYSIS" – when turns on, the machine performs a series of tests to analyze the mains
• "HOT START", "ARC FORCE" and "ANTI STICK"(for more details please refer to the GENERAL PART manual included in the
package).
• "MEMORY PARAMETERS" - the microprocessor stores the welding parameters set during the last use of the machine allowing automatic
recovery each time.
• "VOICE SYNTHESIZER" – it is equipped with a voice synthesizer (the language is selectable at start), that helps the user during its use.
• "ADJUSTMENT PARAMETERS" - the machine is able to self adjust its welding parameters configuration after the user selection

CONTROL PANEL

The machine functions are regulated through the control panel on its front panel, fig1 A.
The control panel consists of a display, a knob for adjusting the welding current, a knob to regulate the voice volume and a knob to select
the electrode.
All manuals and user guides at all-guides.com
Fig 1
Fig 2
GB
DISPLAY : Digital display
LED TERM : This LED indicates if the machine goes on thermal
protection
AMP : the knob regulates the welding current
MENU the Knob selects the ELECTRODE
POT : the knob regulates the VOICE volume
A: control panel
B: Negative socket(-)
C: Positive socket (+)
D: ON-OFF switch
E: Power Cord
6