Power Fist 8416471 Mode D'emploi page 9

8416471
c. Make sure that the protective film is removed from the
new cover lens. Place the new cover lens in the recess
at the front of the helmet (Fig. 5).
2. CHANGE EXTERNAL LENS
a. Replacement of inner cover lens: To remove the inner cover
lens, pulling out the top edge (Fig. 6).
b. The new inner cover lens is installed after the protective film
is removed. Insert the lens' leading edge under the hooks on
either side of the cartridge. Bend the lens in the middle and
slide into place under the hooks (Fig. 7).
c. Insert tabs of the front lens-retaining frame under the two
slots of the back lens-retaining frame (Fig. 8).
For technical questions call: 1-800-665-8685
Auto-Darkening Welding Helmet V 2.0
9