Measuring Procedure; Temperature Alarm - TFA Kitchen Chef Mode D'emploi

TFA_No. 14.1512_Anleitung 14.03.2018
Küchen-Chef – Digital BBQ meat / oven thermometer
D 3: Oven temperature sensor
D 5: Probe connector
6. Getting started
• Plug the probe cable connector into the jack.
• Open the battery compartment and insert two new AAA 1,5 V batteries. Make sure the polarity is correct. All segments
will be displayed briefly.
• Close the battery compartment again.
• The hour digits flash.
• Press the + or – button to set the hours.
• Confirm the setting with the ON/OFF button.
• Set the minutes in the same way.
• Confirm the setting with the ON/OFF button.
• The upper display shows the time, the middle and lower display show the current temperature.
• The device is ready for use.
7. Operation
• Press ON/OFF button to switch the instrument on or off.
• Press and hold the ALARM button to change between °C (Celsius) or °F (Fahrenheit) as temperature unit.
20
9:56 Uhr Seite 11
D 4: Cable
Küchen-Chef – Digital BBQ meat / oven thermometer
• Press the LIGHT button. The backlight is activated briefly.
• Press and hold the + or – button in setting mode for fast mode.
• Press and hold the ON/OFF button in normal mode for three seconds, to enter the time setting mode.

7.1 Measuring procedure

• For measuring the core temperature of meat: Plunge the probe at least 2,5 cm into the middle of the thickest part of the
meat; for poultry, between the torso and the thigh - it should not touch bones or cartilage and it should not protrude from
the meat. Put the meat into the oven and set the relevant oven temperature. The probe should remain in the meat
throughout the cooking process.
• The oven temperature is measured simultaneously.
• Simply run the cable to the outside. The cable adapts to the oven seal. Be careful with sharp-edged frames and hinges.
• Place the thermometer securely near the oven (cable length approx. 120 cm). You can either attach the device onto a
metal surface with its magnet or use the fold-out stand to place it onto a flat surface or to hang it.

7.2 Temperature alarm

• Press the ALARM button to enter the alarm mode.
• "- -" appears on the core temperature display and the symbol
• To activate the alarm press the ON/OFF button. The alarm symbol
• 70°C (default) or the last adjusted value flashes on the display.
• Press the + or – button to set the desired core temperature.
and the alarm symbol flash.
appears.
21