System Messages - KBL megaSun Optima Mode D'emploi

System messages

After the error has been eliminated, all error messages must be acknowledged by pressing START on the interior display
No.
Status message
01 Excess temperature bimetal
canopy
02 Maximum
tanning time!
03 Excess temperature exhaust
fan, please check
04 Connection fan
control faulty
08 Canopy pane open, please
close
10 Bench / bench pane open,
please close
12 KBL7 Hardware error Input-
Controller
13 Maximum write cycle fl ash
memory reached
14 Error! SD card read error
(CRC fault)
15 Error! no access to the SD
card
17 Parameter storage
found, please connect and
restart
18 Parameter storage no valid
serial number
19 CAN-BUS: Interior display
V1 is incompatible
20 CAN-BUS: preSelection dis-
play V1 is incompatible
21 CAN-BUS: audio module full
V1 is incompatible
22 CAN-BUS: RGB module V1
ist incompatible
23 Parameter storage write er-
ror
24 Parameter storage read error
25 Frequency detection: detec-
tion failed!
26 Frequency detection: po-
wer supply connection faulty
(connector X6/E6)!
All manuals and user guides at all-guides.com
ERROR MESSAGES
Description
Bimetal switch triggers.
Enabling signal from coin-box system
comes in longer than the time value
approved under "Maximum tanning time"
(voltage remains connected)
Bimetal switch in the fan triggers.
speed Faulty communication between Mainboard
and fan-speed control.
Contact of the canopy pane has triggered.
Contact of the bench pane has triggered.
Mainboard defective.
Maximum write cycle fl ash memory rea-
ched.
Update via SD card failed (CRC fault).
Update via SD card failed (access error).
not Parameter storage not found, please con-
nect and restart.
Parameter storage no valid serial number.
CAN-BUS operators incompatible.
Parameter storage write error.
Parameter storage read error.
Frequency detection failed.
Frequency detection failed. No mains vol-
tage.
Remedy
Check the air-intake/air-discharge system. Let the
sunbed cool down.
Disconnect from the coin-box system.
Make sure the fan runs freely. Check the air-intake/air-
discharge system. Let the sunbed cool down.
Check / replace the patch cable.
Close the canopy pane and check the contact.
Close the bench / bench pane and check the contact.
Contact your Customer Service.
Contact your Customer Service.
SD card check / replace.
SD card check / replace
Check connector parameter storage. If necessary re-
place parameter storage.
Contact your Customer Service.
Use CAN-BUS operaters V2.
Check connector parameter storage. If necessary re-
place parameter storage.
Check connector parameter storage. If necessary re-
place parameter storage.
Restart the controller. Contact your Customer Service
after the third unsuccessful restart.
Check mainboard connector X6/E6.
U t i l i s a t i o n e t M a i n t e n a n c e |
.
47
Optima