Publicité
Les langues disponibles
Les langues disponibles
① Special flange
self-tapping screws
② Earth wire
③ Upper hinge part
Note: Please hold the door by hand
during step 4 to prevent the door from
dropping.
5. Remove the door and place it on a
smooth surface with its panel upwards.
Lever part① and part④ ,
screws② , as shown in
Change handle③ to the right side, then
install screws② , part① and part④ in turn.
Loosen screws⑦ , detach part⑥ and part⑤ ,
turn part ⑥ over and then install part⑤ and
part⑥ to the left side with screws⑦ .
① Handle covers
1
② Special self-tapping screws
③ Handle
④ Screw hole covers
⑤ Door holder
⑥ Stop block
⑦ Self-tapping screws
2
3
1
2
Place refrigerator flatwise, remove
6.
part③ and
Remove part ② and part① .
① Lower hinge part（right）
② Front foot fixed board
③ Adjustable bottom feet part
④ Self-tapping screws
Unscrew the lower hinge, change it
7.
to the near hole site, and then screw
up and mount the washer.
Repeat step 6, change part① to
8.
left and part② to right and then fix
then loose
them with screws④ .
the picture.
part③ .
Lower hinge part (left)
4
3
11
then
loose
screws④ .
washer
Note: washer may
stick to door.
Finally install
Publicité
