Publicité
Les langues disponibles
Les langues disponibles
Reversing the door
The side at which the door opens can
be changed, from the right side (as
supplied)
to
the
left
installation site requires.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed
from the mains socket.
Tools you will need:
8mm socket wrench
Cross-shaped screwdriver
Thin-blade screwdriver
8mm wrench
Note:
Before
you
start,
refrigerator on its back in order to gain
access to the base. You should rest it on
soft foam packaging or similar material
to avoid damaging the backboard of the
refrigerator. To reverse the door, the
following
steps
are
recommended.
1. Stand the refrigerator upright. Open
the door to take out all door racks (to
avoid damaging the racks) and then
close the door.
2. Lift part ① from the top of the
refrigerator body from the right side
and then take down part ③ and part ④
of the door in the same way. Take
side,
if
the
down part ② and put it back into the
plastic bag.
1
lay
the
2
generally
3. Disconnect electrical connector① as
well as electrical connector② and then
take down part③ .
Door racks
4. Remove the screws ① , loose wire② ,
and remove part③ .
10
① Upper cover
② Upper hinge cover (right)
③ Upper cover of upper door
④ Corner cover
3
1
2
3
Publicité
