Menuett 007757 Mode D'emploi page 52

EN
SPECIFIC FAULTS AND MEASURES
Problem
The status light does not
go on when the plug is
plugged in.
The status lamp goes on,
but pan does not get hot.
The status lamp goes on,
but pan does not get hot.
The heat switches off
unexpectedly when in use
and an audio prompt is
given every second.
Abnormal noise from the
fan motor.
52
Cause
Not supplied with power.
Connection fault for auxiliary
power card and display card.
Auxiliary power card
damaged.
Display card damaged.
Display card damaged.
The induction hob has
overheated.
Fault on fan.
Damaged power card.
Unsuitable pan.
The pan is too small.
Fault on overheating
protection.
Defective fan motor.
Action A
Check that the plug is correctly
plugged in and that the power point
is supplied with voltage.
Check the connection.
Replace power card.
Replace display card.
Replace display card.
Could be because ambient
temperature is too high. Check if
air intake or ventilation opening is
blocked.
Check that the fan is working
properly. If not, replace the fan.
Replace power card.
Use a suitable plan in accordance
with these instructions.
Replace the overheating protection.
Replace the power card if the circuit
for pan detection is damaged.
Replace the fan.