Delta 22-580 Manuel D'utilisation page 13

LEVELING TABLE EXTENSIONS
For optimum performance, level the table extensions,
one of which is shown at (A) Fig. 19, with the
planer table. To check and adjust:
Disconnect machine from power
source!
1. Place a straight edge (B) Fig. 19 on the planer table
with one end of the straight edge extending out
over the infeed table extension (A). Check to see if
the table extension is level with the planer table on
both sides of table extension.
2. If an adjustment is necessary, loosen the locknut
(D) and adjust the stop screw (E) on each side of
the table (A). When they are level, tighten the locknut.
NOTE: If necessary, loosen the three screws (C), adjust the table extension, and tighten the screws (C).
3. Adjust the opposite side of the table extension (A).
4. Check and adjust other table extension.
ADJUSTING THE HEIGHT OF THE OUTFEED ROLLER
Disconnect machine from power source!
1. To check and adjust the outfeed roller, make a gauge
block of hardwood. Follow the dimensions in Fig. 20.
2. Check the knives to be certain that they were inserted
correctly. See "REPLACING KNIVES.
3. Position the gauge block (A) Fig. 21 on the table
underneath the cutterhead. Insert a 0.020" (.5 mm)
feeler gauge on top of the gauge block.
4. Lower the head assembly and rotate the cutterhead
until one of the knives (B) touches the top of the feeler
gauge. NOTE: Pull the guard down (G, inset Fig. 21) to
gain access to the hex hole. Insert the supplied wrench
into the hex hole (F) and turn to rotate the cutterhead.
Tighten the cutterhead lock handle.
5. Remove the feeler gauge and move the gauge block
(A) Fig. 22 under one end of the outfeed roller (C). The bottom of the outfeed roller should touch the top of the
gauge block.
6. To adjust the outfeed roller, loosen the locknut (D) Fig. 22 and use a hex wrench to turn the adjusting screw (E)
until outfeed roller touches the gauge block (A). Tighten the locknut.
7. Repeat this adjustment on opposite side of the outfeed roller.
F
G
A
B
Fig. 21
A
Fig. 19
Fig. 20
C
Fig. 22
13 -
English
B
C
D
3"
1/2"
2"
76.2 mm
12.7 mm
51 mm
4"
101.6 mm
D
E
A
E