ETNA KIV360WIT Mode D'emploi page 34

OPERATION
• If you want to switch On another cooking zone, press the key of the cooking zone you want
to switch On to activate it.
• The power levels of the cooking zones that are not activated will be dimmed in the display.
The power levels of the activated zones will also dim.
• Set the desired power level using the – or + key.
• The set power level appears in the display. After a few seconds, all power levels will be
brightly lit again and the cooking zone will switch On.
When the pan detection symbol flashes:
• you have not placed a pan on the correct cooking zone;
• the pan you're using is not suitable for induction cooking;
• the pan is too small or not properly centered on the cooking zone.
▷ No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn Off after 2 minutes if no suitable pan is placed on it.
▷
If the hob is not used for 20 seconds, it will shut Off automatically.
Note!
Not all 4 zones can be set to a high (setting 9 or boost, depending on the model) at
the same. The 4 zones can be set to a maximum of setting 8 or 9 at the same time
(depending on the model). Another zone needs to be reduced or switched off first if a
higher setting is desired.
The set power level in the display will start to flash. You should then set the zones to
a lower setting!
EN 12