Teka DJE Serie Manuel D'instructions page 9

Cleaning and maintenance
During cleaning and maintenance work, make
sure the safety instructions are complied with.
Cleaning the hood body
• If your kitchen hood is made of stainless
steel, use proprietary cleaners mentioned
in the product instructions.
• If your kitchen hood is painted, use
lukewarm water and a neutral soap.
• Never use metallic scourers, nor abrasive
or corrosive products.
• Dry the kitchen hood using a cloth that
does not produce fibres.
• Do not use vapour cleaners.
Cleaning the metal filters
To remove the filters from their fittings, press
lightly on the locks and then pull them off.
Proceed with the following checks before calling the Technical Service:
Problem
The kitchen hood does not
work.
The kitchen hood does not
extract sufficiently or vibrates.
The lamps do not light up.
When exterior gas extraction is not possible, then the kitchen hood may be set to purify the air
by recycling it through active charcoal filters.
The active charcoal filters have an active life of between three to six months, depending on the
individual conditions of use. These filters cannot be washed nor regenerated. They must be
replaced once their useful life comes to an end.
The manufacturer reserves the right to make changes and corrections to its products as it
deems necessary, without altering their basic characteristics.
The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher. In
this case, it is advisable to stack them
vertically to avoid food residues to stick to
them.
Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this
will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit
them onto the kitchen hood.
Proceed as follows:
• Unscrew the lamp cover.
• Change the broken / burnt out lamp.
• Screw the lamp cover back in.
Problem solving
Possible cause
The mains cable is not connected
to the network.
There is no current in the network.
Filters are saturated with fat.
Obstruction in the air outlet.
The lamps are blown.
The lamps are slack.
Active charcoal filters (Optional)
Changing light bulbs
Solution
Connect the mains cable to the
network.
Provide current to the network.
Change or clean the active
charcoal and/or metal filters.
Remove the obstruction.
Change the lamps.
Tighten the lamps.