Brizo BELO 63052 Serie Manuel D'installation page 15

9
Soap Dispenser Installation
Separate head (1) from body assembly (2).
Make sure gasket (3) is properly seated in
the base of the body assembly. Insert body
assembly through selected hole in sink.
Secure body assembly to sink with nut
(4). From under the sink screw the bottle
(5) onto the body assembly shank. Insert
pump (6) down into the body assembly,
then attach head assembly (1) to pump.
2
3
4
15
1
6
5
Note: To fill, lift the head and pump
assembly out of the bottle and pour
not more than 8 oz. into bottle. DO
NOT remove the bottle each time as
this weakens the neck. Use a funnel to
help prevent spills. Pull pump and head
assembly out occasionally to soak and
pump warm water through pump to
remove soap build-up.