Télécharger Imprimer la page

ims PRO TIG TITANIUM 400 AC/DC Mode D'emploi page 27

Masquer les pouces Voir aussi pour TIG TITANIUM 400 AC/DC:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
EQUIPMENT INSTALLATION
• Put the machine on the floor (maximum incline of 10°).
• Provide an adequate area to ventilate the machine and access the controls.
• This equipment must be used and stored in a place protected from dust, acid, gas or any other corrosive substance.
• The machine must be placed in a sheltered area away from rain or direct sunlight.
• The equipment protection is rated IP23 meaning that :
- sensitive parts of the equipment are protected from objects with a diam >12.5 mm and,
- it is protected again rainfall with a 60° vertical incline.
The equipment can be used outside in accordance with the IP23 protection certification.
Power cables, extension leads and welding cables must be fully uncoiled to prevent overheating.
The manufacturer does not accept any liability in relation to damages caused to objects or harm caused to persons as the result
of incorrect and/or dangerous use of the machine.
MAINTENANCE / RECOMMENDATIONS
• Maintenance should only be carried out by a qualified person. A yearly maintenance is recommended.
• Ensure the machine is unplugged from the mains, and then wait 2 minutes before carrying out maintenance work. High Voltage
and Currents inside the machine.
• Remove regularly the casing and any excess of dust. Take this opportunity to have the electrical connections checked by a qualified person, with
an insulated tool.
• Regularly check the condition of the power supply cable. If the power cable is damaged, it must be replaced by the manufacturer, its after sales
service or an equally qualified person to prevent danger.
• Ensure the vents of the device are not blocked to allow adequate air circulation.
• Do not use this equipment to thaw pipes, to charge batteries, or to start any engine.
INSTALLATION – PRODUCT OPERATION
Only qualified personnel authorised by the manufacturer should perform the installation of the welding equipment. During the installation, the
operator must ensure that the machine is disconnected from the mains. Connecting generators in serial or in parallel is forbidden.
EQUIPMENT DESCRIPTION (FIG-1)
The TITANIUM 400 AC/DC is an inverter welding current source for welding to the coated electrode (MMA) and refractory electrode (TIG) in direct
current (TIG DC) and alternating current (TIG AC).
The MMA process allows to weld all types of electrodes : rutile, basic, stainless and cellulosic.
TIG welding requires gas shield protection of pure gas (Argon).
This material can be connected to a remote control (ref. 045675), a foot pedal (ref. 045682) or an automated system (CONNECT-5).
1-
HMI
2-
Handles
3-
Torch button connector
4-
Positive polarity plug
5-
Polarity plug
6-
Torch gas connector
7-
Wire feeder connector or MMI remote interface
INTERFACE (MMI) (FIG-2)
1-
Button for accessing the various menus and parameters
2-
Adjustment wheel left screen
3-
Adjustment wheel right screen
ACCESSORIES AND OPTIONS
Trolley
Cooling unit
10 m
WCU1KW_C
3
037328
IMS TIG TITANIUM 400 AC/DC
Torches ABITIG
liquides - 450 W - 8 m
Double button: 037366
013537
Lamella: 037359
Potentiometer: 060760
8-
USB connector
9-
ON / OFF switch
10-
Power supply cable
11-
Remote controller connector
12-
Gas bottle connector
13-
Filter (option ref. 046580)
Remote controllers
Pedal RC-FA1
Manual RC-HA1
4 m
045682
EN
Filter
8 m
045675
046580
27

Publicité

loading