Table des Matières
Publicité
8
Esc
Introduction
Alignment
10
11
Esc
Introduction
1
35 mm (1.5")
Click the 'forward arrow' button to go to the next page
30
Finish
×36
Alignment
Finish
2
9
Esc
Introduction
Touch Module alignment
You will be optimizing touch detection by adjusting the touch module so that it can see all corners of your
markerboard/surface.
In order to complete the touch module alignment process, you will:
1. Set HOME position
2. Use the Alignment Tool to complete a series of traces.
3. Adjust the dials on the Touch Module.
After setting HOME position, the alignment process should take 5-10 mins.
Click the 'forward arrow' button to go to the next page
3 min
Alignment
Finish
1018488 Rev 06
Publicité
Table des Matières
