Operating Procedure; Bec-System/Connections To Receiver - Carson REFLEX WHEEL PRO Mode D'emploi

Operating procedure

Many publications say that the setup sequence
for the transmitter and receiver don't play a
role anymore with 2.4 GHz sets. However, we
recommend sticking to the sequence typical for
previous sets.
• Before operation: First turn on the transmitter,
then the receiver. Lastly, connect the drive
battery to the control unit.

BEC-System/Connections to Receiver

BEC-receiver:
Battery eliminator is installed in the receiver
circuitry. The receiver gets supplied with current
through the drive battery that runs the engine.
NiMH battery from 6 V to 8.4 V can be used for
Electronic speed controller
(not included)
Receiver
Do not connect a separate power
supply to the receiver!
CARSON Reflex Wheel Pro 2,4 GHz 50 050 0032
• After operation: Disconnect the battery from the
control unit. Turn the receiver off, and then the
transmitter.
• Before and after operating the transmitter, make
sure that trim is in the desired place and that all
checks have been made.
the receiver. Batteries of higher voltage may
damage the receiver and servos.
Use only a speed controller which has the exclusive
connector for the BEC system.
Connector motor
Connector battery
Power switch On-/Off
Steering servo
Channel 1
(not included)
ATTENTION
Make sure that male and female connectors
have the correct polarity!
GB
19