Lamborghini Caloreclima ECO 30 Notice D'installation Et D'entretien page 35

Masquer les pouces Voir aussi pour ECO 30:

Les langues disponibles

PRESSURE PUMP ADJUSTMENT

The pump is pre-set at 12 bar.

To control the pressure, use the oil pressure gauge.

Normally, the pressure is set between 11 and 15 bar.

1 - Suction feed

2 - Return

3 - Choke

4 - Pressure control

N.B.: If the vacuum exceeds 4 m., utilise a circulation pump

COMBUSTION CONTROL

In order to obtain optimum combustion efficiency, also with respect to the environment, it is advisable to use the

appropriate instruments when controlling or regulating combustion. The fundamental levels to consider are:

Indicates the volume of air used in combustion; if air volume is increased, the level of CO

decreases and if the volume of air is decreased, the level of CO

12%.

Smoke emissions control (Bacharach). It is important to note the presence of non-burned solid particles

in smoke. If the level of particles in the smoke exceeds n° 2 on the BH scale, the choke should be checked

for defects and that it is the proper choke for the burner and furnace (brand, type, angle of atomisation).

Generally, the n° BH tends to diminish by raising pump pressure; it is necessary in this case to control the

amount of fuel flow, which will increase and therefore, it may be necessary to reduce the capacity of the

choke.

Smoke temperature. This level represents the dispersion of heat through the chimney; the higher the

temperature is, the higher the dispersion of heat will be as well as a lower effective out-put from the

combustion.

ECO 30/2 – ECO 40/2. With the burners working at low or high flame, it is necessary to check that they do

not create the conditions for condensation in the smoke, in the furnace or in the chimney. Condensation,

which is typically acid, can provoke serious corrosion in the furnace. Therefore, it is necessary to consult the

manufacturer on this problem. Regarding the chimney, depending on the material used in construction, corrosion,

stains from humidity or difficulties in the dispersion of smoke can occur.

N.B. : Existing regulations in certain countries could differ from the stated values herein and require adherence

to different parameters. The burners are designed for conformity to the most rigid international regulations

for energy conservation and respect for the environment.

% increases. Acceptable levels are 11-

Eco 30/2 Eco 40/2