Yakima BedHead Instructions De Montage

Loosen Bolt
Use enclosed
wrench and
loosen enough
to separate
pieces.
Tighten
Be sure that bolt aligns
with indentation in the fork
block. Do not overtighten.
TeST by grabbing and
shaking. If BedHead slips
or loses contact with rail,
tighten more.
BefoRe
DRiving
away!
This limited lifetime warranty covers all Yakima-brand products* and rack components manufactured by Yakima Products, Inc. (Yakima), and is effective for as long as the original
retail purchaser owns the product. This warranty terminates when the original retail purchaser sells or otherwise transfers the product to any other person. Subject to Yakima's
inspection of the product, Yakima will remedy defects in materials and/or workmanship by repairing or replacing, at Yakima's option, the defective product without charge for parts
or labor, subject to the limitations and exclusions described in this warranty. Yakima may elect, at its option, not to repair or replace a defective product, in which case Yakima will
issue to the original retail purchaser, at Yakima's option, either a refund equal to the purchase price paid for the product, or a credit to be used toward the purchase of new Yakima
products or rack components. This warranty does not cover problems caused by normal wear and tear (including, but not limited to, scratches, dents, or aesthetic oxidation of
surfaces), accidents, unlawful vehicle operation, or modifications or repairs not performed or authorized by Yakima. In addition, this warranty does not cover problems resulting
from conditions beyond Yakima's control including, but not limited to, theft, misuse, overloading, or failure to assemble, mount or use the product in accordance with Yakima's
written instructions or guidelines included with the product or made available to the original retail purchaser. If a product is believed to be defective, the original retail purchaser
should contact the Yakima dealer from whom it purchased the product, who will give the original retail purchaser instructions on how to proceed. If the original retail purchaser
is unable to contact the Yakima dealer, or the dealer is not able to remedy the defect, the original retail purchaser should contact Yakima by e-mail at: yakwarranty@yakima.com,
or phone 888.925.4621 for shipping instructions. Upon contacting Yakima directly, a Yakima technician will provide the original retail purchaser with appropriate instructions for
returning the product to Yakima. The original retail purchaser will be responsible for the cost of mailing the product to Yakima. In order to receive any remedy under this warranty
(either from a Yakima dealer, or from Yakima directly), proof of purchase in the form of an original purchase invoice or receipt is strictly required.
1032373C- 1/2
BedHead
The Bedhead is designed to attach
to standard pickup bed rails. Bed
liners may need alteration.
Position Rail Clip
Hook rail clip under bed
rail. Position rail clip
only where underside
of rail is flat. Loosen
bolt more if necessary,
and rotate
into upright
position.
Replace
skewer and
attach the nut.
Test installation by grabbing and shaking.
TighTen if anyTHing iS LooSe!
LiMiTeD LifeTiMe waRRanTy
Remove Skewer
Unscrew
and remove
adjustment nut.
Slide skewer out.
Position fork Block
Slide fork block into position
with rail clip as shown.
if BeDHeaD iS noT fLaT on
RaiL oR wiLL noT fiT:
Check that rail clip is positioned where the
underside of rail is flat or remove rail clip
and rotate the black, rectangular pad.
Reassemble and TIgHTen.
Set the bicycle
forks onto the
skewer.
• Periodically check that bolt is tight.
• Secure rear wheel to prevent shifting.
Secure Bike
Loosen or tighten the
adjustment nut as needed so
that lever closes with some
resistance.
Part #1032373 Rev.C