Adjusting The Bevel Angle - Black & Decker FIRESTORM FS1300CSL Manuel D'instructions

642742-00 01 FS1300 FS1500CSL
• Move the saw shoe (6) into the desired
position. The corresponding depth of
cut can be read from the scale (13).
• Tighten the lever to lock the saw shoe
in place.
• Set depth adjustment of saw such that
one tooth of the blade projects below
the workpiece as shown in figure 8.
7
8
Surface of wood

ADJUSTING THE BEVEL ANGLE

(FIG. 9)
This tool can be set to bevel angles
between 0° and 45°.
• Loosen the locking knob (14) to unlock
the saw shoe.
• Move the saw shoe (6) into the desired
position. The corresponding bevel
angle can be read from the scale (15).
• Tighten the locking knob to lock the
saw shoe in place.
9
15
All manuals and user guides at all-guides.com
11/29/07 2:18 PM
ATTACHING AND REMOVING THE
BLADE
REMOVING THE BLADE (FS1500CSL)
(FIG. 10 & 11)
• Keep the spindle lock button (5)
depressed and rotate the blade until
the spindle lock engages.
• Loosen and remove the blade retaining
screw (16) by turning it counter-
13
clockwise using the wrench (10)
supplied.
• Remove the outer washer (17).
• Remove the saw blade (7).
10
12
Tip of tooth
11
ATTACHING THE BLADE (FS1500CSL)
• Place the saw blade (7) onto the inner
flange (18), making sure that the arrow
on the blade points in the same
direction as the arrow on the tool.
• Fit the outer washer (17) on the
spindle, with the raised part pointing
14
away from the saw blade.
• Insert the blade retaining screw (16)
into the hole.
• Keep the spindle lock button (5)
depressed.
• Securely tighten the blade retaining
screw by turning it clockwise using the
wrench (10) supplied.
8
Page 8
5
18
17
16
7
10