R&G CP0199BL Instructions De Montage

FITTING INSTRUCTIONS FOR CP0199BL/WH AERO CRASH PROTECTORS
TOWARDS REAR
OF BIKE
Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike
Please note that in cases where kits are packed with rubber washers holding the components onto the bolt – the rubber
washers should be thrown away!
Left-hand side (as you sit on bike)

Remove lower (webbed) fairing as shown above left

Remove the engine bolt arrowed above left

Remove aluminium spacer from between frame spar and engine mount

Slide block with deeper nesting shape between frame spar and engine mount as shown above

Replace OEM bolt through frame into engine mount (in effect replacing spacer with new block)
and tighten

Replace fairing

Install the longer M12 (80mm) bolt and a washer, followed by a shake proof washer, into bobbin
counter bore, place the spacer over the free end of bolt and fit to bobbin spigot and tighten bolt
until you feel some compression from inside the protector. PLEASE NOTE BOBBIN MUST BE
POSITIONED AS PICTURED ABOVE WITH BIGGER END TOWARD FRONT OF
BIKE. Turn a little more so that you feel the compression increase slightly. Then apply a quarter
Unit 5K, Blacknest Industrial Park, Blacknest Road, Alton, Hampshire, GU34 4PX
Tel: +44 (0)870 220 6380 Fax: +44 (0)1420 521101
HONDA CBR600RR 2007-2008
R&G Racing
www.rg-racing.com
TOWARDS FRONT
OF BIKE
Email: info@rg-racing.com