Etac Turner PRO Mode D'emploi page 2

Turner PRO
Reconditioning
EN
1
Washing
• Use a solvent-free detergent with a pH level bet-
ween 5 and 9.
• Can be washed at 70° C for 10 minutes.
• Lay the Turner PRO on the floor in an angeled position
after washing, so the water runs out of the rotating
mechanism.
• You may also use copressed air to blow dry inside
rotating mechanism.
2
Rotating mechanism
If turner rotates porly:
• Unscrew bolt (5).
• Clean Low friction disc (2) and floor plate (1).
• If deep groves or damages in (1) or (2), replace
(1,2,3,4,5).
• Apply loctite 243 or simular on bolt (5), tighten bolt
firmly (approx 20Nm).
If antislip knobs are missing:
• Clean holes.
• Apply Loctite 460 and push in new knobs.
3
Wheels / Wheel axles
• Controls wheel and shaft for wear.
• Check if the wheels turn easily, remove hair and dirt.
If wheels are worn out, or still rotates porly after
cleaning:
• Flip out starlock with
an screwdriver or
simular (1).
• Remove bolt and
wheel.
• Replace 1,2,3.
• Place wheel between
forks.
• Insert bolt and knock
.starlock in place.
2
5
3
4
1
2
3
2
1