Etac Turner PRO Mode D'emploi page 3

Turner PRO
Reconditioning
EN
4
Leg Support
• Check bracket on leg support for cracks and
wear. If cracs, replace coplete leg support.
• Check cushion for wear, should be tight and firm
around the pipe. If loose or damaged, replace
coplete leg support.
If complete leg support needs to be replaced:
• Unscrew bolts and remove outer pole.
• Pull leg support out of pole.
• Insert leg support with kneepads pointing upwards
• Make sure both knobs are on the same side (1).
• Tighten knob by turning knob clockwise (2).
1
Reconditioning
2
• Place the base plate on an even surface. Insert
pole
the wheels.(1)
• Insert all three screws into holes in the base
plate. Use allen key to screw in bolts. Apply
loctite 243 or simular
bolt firmly, (approx 20Nm). (2)
1
5
Main plate/outer pole
• Check for cracks and wear on main plate and
outer pole. If cracks, replace complete Turner-
PRO.
• Check bolted conection between pole and
main plate (3 bolts), if loose bolts tighten all
bolts.
6
• Check for cracs and dents, if cracs or dents
replace inner pole.
Original spare parts from Etac should always be used.
3
with knee pads facing away from
on bolts, tighten
2
Handle/inner pole