Maintenance and Cleaning Instructions
Cleaning
•
Important: The sensor lenses located on front and rear sides of the drying cavity should be routinely cleaned to
maintain proper operation.
•
All surfaces of the hand dryer can be cleaned with a soft cloth and non-abrasive, non-caustic cleaning solution.
•
Provided cleaning brush should be used for cleaning the drain hole in the bottom of the drying cavity.
Maintenance
Emptying the Water Collection Tray
1. The water collection tray will fill with water with hand dryer use.
2. Regularly check the water tank status on the LED display panel. The LED Display will indicate when the water
collection tray is full and needs emptying.
3. If water collection tray is not emptied when full, the collection tray will overflow onto the floor. High washroom traffic
may require more frequent emptying of the water collection tray.
4. For optimum hygiene, routinely clean the water collection tray with a non-brasive, non-caustic cleaning solution.
HEPA Filter with Odor Neutralizing Tablet
1. This hand dryer is equipped with removable intake air pre-filter and a replaceable cartridge containing a HEPA filter and
an odor neutralizing tablet.
2. Regularly check the filter status on the LED display panel. The LED display panel will indicate when the HEPA filter
requires replacement. High washroom traffic may require more frequent replacement of the HEPA filter.
3. The removable intake air pre-filter can be cleaned and re-used.
Caution: Failure to replace a used / dirty HEPA filter can cause overheating of the hand dryer's motor and may
invalidate your warranty rights.
Replacement filters can be purchased through your dealer where you purchased the hand dryer or through BRADLEY.
Please contact 1-800-BRADLEY.
Troubleshooting Chart
Problem
The hand dryer fails to start.
Warranty
Product warranties may be found under "Products" on our website at www.bradleycorp.com.
All manuals and user guides at all-guides.com
Action
Check the power supply is turned on.
Check the hand dryer's internal power switch (remove water tray to
access - see Dryer Controls section in this manual) is switched on.
Clean sensor area inside drying cavity.
6
WWW.RESTROOMDIRECT.COM
704 • 937• 2673
129 Oakpark Dr., Unit A, Mooresville, NC 28115