Manually Connecting The Subwoofer Or Surround Speakers - Samsung HW-Q990B Manuel

Manually connecting the Subwoofer or Surround Speakers

Before performing the manual connection procedure below:
• Check whether the power cables for the Soundbar and subwoofer or Surround Speakers are connected properly.
• Make sure that the Soundbar is turned off.
1. Turn off the Soundbar main.
2. Press and hold ID SET on the rear of the subwoofer and surround speakers for at least 5 seconds.
• The red indicator at the rear of each speaker turns off and the blue indicator blinks.
3. Press the Up button on the remote control for 5 seconds.
• The ID SET message appears on the display of the Soundbar for a moment, and then it disappears.
• The Soundbar will automatically power on when ID SET is complete.
4. Check if the LINK LED is solid blue (connection complete).
LINK LED - Blue is On
5 Sec
Rear of Subwoofer
x 2
POWER
Rear of the Left and Right Surround Speakers
5 Sec
The LINK LED indicator stops blinking and glows a solid blue when a connection
is established between the Soundbar and the Wireless Subwoofer, surround
speakers.
Rear of Subwoofer
5 Sec
ID SET
ENG - 14
Blinking
blue fast
Blinking blue fast