Fanimation ROTATION FP8018 Serie Mode D'emploi page 9

How to Hang Your Ceiling Fan (Continued)
2. Attaching Ceiling Support Cable (Figure 4):
Drill 1/4˝ pilot hole through into the ceiling joist or
structural member. Securely attach the ceiling support
cable with 3/8˝ x 2˝ lag bolt and flat washer.
NOTE: Ceiling support cable must be directly secured
to ceiling joist or structural member between flat
washer and outlet box with 2˝ lag bolt. (Figure 4)
3. Hanger Bracket Attachment:
Securely attach the hanger bracket to the outlet box
using the outlet box screws and washers supplied with
the outlet box. (Figure 4)
4.
Assemble and secure the assembled fan with hex-
head bolt, two lockwashers, nylon locknut and hairpin
clip. (Figure 5)
WARNING
It is critical that the clevis pin and lock nut in the
hanger bracket/downrod area is properly installed.
Failure to verify that the nut and hairpin clip are
properly installed could result in the fan falling.
INSTALLATION NOTE
The hanger bracket angle adjustment MUST ONLY be
used to orientate the downrod in a vertical downward
position.
5. (Optional) Sloped Ceiling Installation (Figure 6):
Loosen two nuts located on both sides of the hanger
bracket to orientate the downrod in the vertical
position.
6.
Make sure the electrical supply wires, including the
hanger bracket grounding wire and safety cable are
pulled through the downrod, between the hanger
bracket and the outlet box so that electrical
connections can be made later.
7.
Attach the safety cable to ceiling support cable.
Slide cable clamp onto safety cable (from fan). Place
the end of cable through the loop of ceiling support
cable. Pull as much cable through loop as possible.
Feed end of cable into clamp hole and firmly tighten
screw (Figure 7). Cut off excess safety cable.
WARNING
To avoid possible shock, do not pinch wires between
the downrod and the hanger bracket.
Ceiling
Ceiling
Support
Cable
Sloped
Ceiling
NOTE: Supply wires
and fan wires omitted
for clarity
9
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Outlet Box
Hanger Bracket
Figure 4
Downrod (Assembled Fan)
Figure 5
Loosen Nuts on
both sides of the
Hanger Bracket
Figure 6
Attach
Safety Cable
to Ceiling
Support Cable
Figure 7