Best PIK33D Guide D'installation page 8

11. INSTALL THE TRANSITION
Attach the transition to insert top. Use duct tape to make all joints secure
and airtight.
12. DUCTING CONNECTION
A. When there is access to the top of the hood, connect ductwork and
seal connections with duct tape after Step 13 Install the insert.
B. When there is no access to the top of the hood, carefully pull down
the metal duct through the custom hood base hole. Slide this duct
over the transition. Seal the connection with duct tape.
Take care not to kink ducting when installing insert (step 13).
13. INSTALL THE INSERT
Install the insert inside the custom hood
and secure to the frame by using the
no. 8 x 3/4" mounting screws provided.
Position insert rearward so 3½'' notch
from step 6 is covered. Start with 2 front
screws on top, then 2 rear screws on top,
and finish with 2 on rear side.
(See figure beside for mounting screw
specific locations.)
Take care not to kink ducting or pinch electrical cable when installing insert.
CAUTION
TOP
HD0102
CAUTION
- 8 -
HD0057
HD0092
REAR