Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
16. INSTALL BAFFLE FILTERS
Remove protective plastic film covering the baffle filters before installing them.
It is recommended to install side filters first and finish with center one.
A vertical arrow with the word AIR can be found on the filters border. Make sure to
install the baffle filters with the arrow pointing towards the inside of the hood insert.
See figure beside.
1.
Insert upper end of baffle filter into the insert.
2.
Raise lower end of baffle filter to position inside of unit and push to insert the
rear clip inside its slot in baffle back side.
3.
While pushing the baffle filter, slide it under the inner retaining piece.
Make sure the baffle filters are positioned as shown beside in order to allow the
grease to reach the grease rail easily.
17. USE AND CARE
Before servicing or cleaning the unit, switch power off at service panel and lock service panel to prevent
power from being switched on accidentally. When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag, to the service panel.
B
AFFLE FILTERS AND IMPELLER
The baffle filters, impeller(s) and grease rail should be cleaned frequently. Use a warm detergent solution. Baffle filters and
impeller(s) are dishwasher safe.
Remove baffle filters by pushing them towards the back of hood and rotating downward.
Clean all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of the filter may occur if using phosphate detergent
or as a result of local water conditions—but this will not affect filter performance. This discoloration is not covered by the warranty.
Stainless steel cleaning: How to maintain its "BRIGHT LOOK" and help prevent corrosion.
Do:
• Once a month, wash surfaces with clean cloth or rag soaked with warm water and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning. Wipe dry completely.
• You may also use a specialized household stainless steel cleaner.
Don't:
• Use any steel or stainless steel wool or any other scrapers to remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the hood. During construction or renovation, cover the hood to
make sure no dust sticks to stainless steel surface.
Avoid: when choosing a detergent
• Any cleaners that contain bleach will attack stainless steel.
• Any products containing : chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
• Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and
should never be used close to a range.
(
).
S
CAUTION
WARNING
!
- 11 -
HO0021
1
2
3
HD0090
Publicité
Table des Matières
