Venga SWM 3000 Mode D'emploi page 9

26. Power Cord has one end that connects into the power cord socket and
another end that is connected to a mains power supply.
27. Foot Controller is used to start the machine sewing. Step on the controller to
begin sewing and remove your foot from the controller to stop sewing.
28. Presser Foot Lifter is located inside the "C" area of the machine. Use the lever to
raise and lower the presser foot. The foot is raised before threading the machine
and to remove work from the machine. Lower the presser foot lifter before
beginning to sew.
29. Light Switch & Built-in Sewing Light are used to illuminate the sewing area.
30. Faceplate houses the take-up lever, sewing light and tension mechanism.
31. Thread spool is used to hold and direct the thread into the tension discs. There is
a diagram at the top of the machine indicating where the thread slips into the
guide.
32. Bobbin case holds the bobbin thread securely, providing adequate tension on
the thread while sewing.
ACCESSORIES
Foot pedal
XI
Thread spool
X2
Bobbin
X2
Needle XI
threader
Needle
XI
REMOVING / INSTALLING EXTENSION BED
To remove the extension bed from the machine, hold It firmly and pull It toward the left.
Once removed, you will have access to the free arm. This allows you to sew pants or
sleeve hems, as well as other hard-to-reach areas.
IMPORTANT!
Only use metal bobbins in this sewing
machine. The tension on the bobbin
thread is operated magnetically and
therefore the metal bobbin is
required. Using transparent or plastic
bobbins, though they may seem to fit
in the machine, will not allow the
machine to function properly, and
the stitch result will be unsatisfactory.
Using metal bobbins will provide
correct stitch results.