Sewing on a Button
Set the machine for Stitch
or #7, depending on the distance between the holes of the
#6
button. Position the fabric and button under the presser foot.
Lower the presser foot.
Turn the handwheel to make sure the needle clears both left and right hole
Note: It may be necessary to change to a different zig-zag stitch selection until you find
the one that is appropriate for the button. To do so, raise the needle out of the fabric,
select the new stitch. Lower the presser foot and then turn the handwheel to see if it
clears the holes of the button.
Once you have determined the correct zig-zag stitch setting for the button, sew 10
stitches. If a button shank is required, place a needle on top of the button and sew over
the top of it, as shown.
When finished, pull both threads to the backside of the fabric using a hand needle, then
tie together to secure.
CHANGING THE BULB
Disconnect the machine from the power supply be removing the plug from the main
socket. Replace the bulb with the same type rated (≤ 0.6W and LED Voltages ≤ 3.2V, Ø
5mmLED)