Venga SWM 3000 Mode D'emploi page 3

damaged, or come into contact with water. Return the
machine to the nearest authorized retailer or service center
for examination, repair, or electrical or mechanical
adjustment.
Never operate the machine with any air openings blocked.
❑
Keep ventilation openings of the sewing machine and foot
controller free from accumulation of lint, dust and loose
fabrics.
Keep fingers away from all moving parts. Special care is
❑
required around the sewing machine needle.
Always use the correct needle plate. The wrong plate can
❑
cause the needle to break.
Do not use bent needles.
❑
Do not pull or push the fabric while stitching, as this may
❑
deflect the needle, causing it to break.
Switch the sewing machine off when making any adjustments
❑
in the needle area, such as threading the needle, changing
the needle, threading the bobbin, changing the presser foot,
etc.
Always unplug the sewing machine from the electrical outlet
❑
when replacing accessories, removing covers, or when
making any other user servicing adjustments mentioned in
the instruction manual.
Never drop or insert any object into any opening.
❑
Do not use outdoors.
❑
Do not operate where aerosol spray products are being used
❑
or where oxygen is being administered.
To disconnect, turn all controls to the Off position, then
❑
remove the plug from the electrical outlet.
Do not unplug by pulling on the cord. To unplug, grasp the
❑
plug, not the cord.
The sound pressure level under normal operation conditions
❑
is 72db.
Turn off or unplug the machine when if you suspect the
❑
appliance is not operating properly.