Venga SWM 3000 Mode D'emploi page 17

RAISING THE BOBBIN THREAD
Before you start to sew, it will be necessary to draw up the bobbin thread.
Please see the table below to check the corresponding numbers, as follows:
1. Raise the presser foot lifter
2. Remove bobbin cover plate.
3. Hold the needle thread loosely with your left hand
4. Turn the hand wheel toward you (counter-clockwise) with your right hand, first
lowering the needle and continuing until the needle comes to its highest position.
5. Lightly pull up the top thread, and pick up the bobbin thread
6. The bobbin thread will appear through the needle plate slot.
7. Pull both the top and bobbin thread together toward the back of the machine
under the presser foot, leaving about 6" clear.
8. Replace the bobbin cover plate cover.