Publicité
Step 12
Carefully turn your unit over onto its front edges. Unfold the BACK (G)
å
and lay it over your unit.
Make equal margins along all four edges of the BACK (G). Push on
å
opposite corners of your unit if needed to make it "square".
Fasten the BACK (G) to your unit using the NAILS (QQ).
å
NOTE: Be sure to tap NAILS into the holes that line up over the UPPER
å
SHELF (F) and UPRIGHTS (C and D).
NOTE: Perforations have been provided for access through the BACK.
å
Carefully cut out the holes needed.
Fasten the EXTENSION BLOCK (K) to the SHORT UPRIGHT (D). Use two
å
BLACK 2-3/4" FLAT HEAD SCREWS (KK).
Push the PLASTIC FOOT (Y) into the hole in the EXTENSION BLOCK (K).
å
Y
Page 16
These holes must line up over
the SHELF and UPRIGHTS.
G
D
K
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
BLACK 2-3/4" FLAT HEAD SCREW
(2 used for the EXTENSION BLOCK)
409242
QQ
NAIL
(47 used for the BACK)
Cut-out (used for lifting)
KK
www.sauder.com/services
Publicité
