Samsung DVD-VR335 Manuel D'instructions page 24

Step 4 : Connecting HDMI/DVI to a TV
Connecting to a TV with HDMI Jack
Using an HDMI- HDMI cable(not included) connect the HDMI OUT jack on the rear of the DVD Recorder to the HDMI
IN jack of your TV.
Press the input selector on your TV remote control until the HDMI signal from the DVD Recorder appears on your TV
screen.
To hear audio on your TV when using HDMI, set the
s
digital audio output to PCM (2 channel).(See page 37)
Caution
Depending on the HDMI device(TV/HDMI Receiver)
s
you use, audio may not be supported. If TV does not
support Dolby digital/DTS, Audio output is not avail-
able when you set Digital output as Bitstream or
select DTS On in Audio setup menu. In this case, set
the digital audio output to PCM or DTS Off.
24 - English