BOMANN KB 7245 Mode D'emploi page 24

• Then you may restart the appliance by connecting
the plug and turning the temperature control.
Replacing the door hinge
If the appliance door starts to stutter, crack or jam
when you open it, it is probably due to a worn or
damaged hinge.
It is recommended to replace all door hinges at the
same time, otherwise the next repair will soon be
beckoning.
• Remove the contents of the appliance and the
movable interior parts.
• Tilt the appliance backwards and block it in this
position to prevent the door from sliding out.
• Loosen the hinge cover as described under
versing the door opening"
upper door hinge.
• Turn out the stand and disassemble the lower
door hinge.
• The respective hinge assembly is carried out in
reverse order.
• Open and close the appliance door for a test run,
readjust the hinges if necessary. In any case,
make sure that the door fits tightly and accurately.
Troubleshooting
Before you contact an authorized specialist
Problem / cause / action
Appliance is not working properly or at all
- Check the power supply / temperature setting /
ambient temperature.
- Unblock the ventilation openings, install the ap-
pliance freely.
"Re-
and disassemble the
Problem / cause / action
Loading is too warm
- Check the temperature setting / ambient temper-
ature.
- A large quantity of warm food has been stored in
the unit in the last 24 hours.
- The appliance door is not closed properly, check
the door seal.
Loud noise during operation
- Check that the appliance is level.
"Operating noise"
- See
Water on the appliance bottom
- Check the temperature setting.
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.
Technical data
Climate class SN/N/ST/T: this appliance is intended
to be used at ambient temperature ranging from
10°C to 43°C.
Electrical connection............................................
Power voltage: .........................220-240 V~ / 50 Hz
Rated power: ..............................................60 W
Rated current: .............................................0.6 A
Dimension H x W x D / weight...............................
Appliance size: ......................50.0 x 44.5 x 46.8 cm
Net weight: ..................................approx. 14.0 kg
For more information about the product, scan the QR
code on the supplied energy label and/or visit the of-
ficial website of the product data bank:
https://eprel.ec.europa.eu
The right to make technical and design modifications
during continuous product development remains re-
served.
This appliance has been tested according to all rele-
vant current CE guidelines, such as electromagnetic
24
.