Startup / Operation - BOMANN KB 7245 Mode D'emploi

• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
You possibly need:
screw wrench, Phillips screw-
driver as well as a thin-blade screwdriver.
• Remove the blind cap (1) and the hinge cover (2).
• Disassemble the door hinge (3). Lift out the appli-
ance door and place it safely to the side.
• Tilt the appliance slightly backwards and block it
in this position. Unscrew the stand (4) and disas-
semble the door hinge (5).
• Relocate and fasten the door hinge (5). Screw in
the stand (4) accordingly.
• Replace the appliance upright. Place the appli-
ance door and fix it in the intended position. Relo-
cate the fasten the door hinge (3).
• Replace the hinge cover (2) and move the blind
cap (1) into the exposed hole.
Check if the door is aligned vertically and horizontally
optimally so that the smooth opening and closing of
the door is guaranteed.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and maintenance"
the chapter
Starting the appliance
• Connect the appliance to the power supply.
• Set the operating conditions. See also the follow-
ing sections.
Settings
Position [ OFF ] means that the appliance is in the
switched-off state. Turn the temperature control
clockwise from this position, the appliance switches
on automatically.
The power levels control the different values of the
internal temperature.
Power level
lowest level,
MIN
warmest internal temperature
medium level,
MED
optimal operating temperature
highest level,
MAX*
coldest internal temperature
20
.