Publicité
STEP 1
Note: If you are installing a
Casserole Dish Storage unit,
please skip to step 2.
To attach the upper tray, fully
extend and disengage the slide
rails from the slides by pressing the
release levers. Use the provided
(4) #6 X 3/8" flat head screws to
attach the slide rails to the upper
tray using the pre-drilled holes
located on each side of the tray
and then re-engage by sliding the
slide rails onto the slides
(See Figure 1A and 1B).
#2
STEP 2
To assemble the bottom mount
slides, attach the slide strap feet to
the slide straps (See Figure 2A).
Attach the left and right slides to
the top of the feet. You will hear/
feel a "snap" when connected
completely (See Figure 2B).
Once slides are assembled, set
them to the side (See Figure 2C).
STEP 3
Turn your wood box over and
locate the pre-drilled holes on
the front lip of the box
(See Figure 3A).
Using (4) #6 X 1/2" pan head
screws, attach the left and right
slide triggers and set the wood
box to the side (See Figure 3B).
If you are installing a casserole dish
storage unit, find the left and right
triggers and install the triggers on
the correct side using (4) #6 X 1/2"
pan head screws (See Figure 3C
& 3D).
Note: Release triggers are side
sensitive and are marked with an
"L" & "R" for Left and Right.
#2
STEP 4
Note: If you are installing a
cookware organizer unit, skip to
step 5.
Take the handle and press it down
in the required holes in the front of
the dish storage unit. Use a rubber
mallet to gently tap the handle firmly
STEP 5
Use instructions on the template
to complete installation
(See Figure 5).
2
FIGURE 1A
Disengage Slides
FIGURE 2A
FIGURE 3A
Pre-drilled holes
FIGURE 3C
Customer Service: 800-626-1126 | rev-a-shelf.com
Screw locations
FIGURE 2C
FIGURE 2B
Slide triggers
FIGURE 3D
FIGURE 4
FIGURE 1B
FIGURE 3B
FIGURE 5
Publicité
