Yakima KingJoe Pro 2 Notice De Montage page 4

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Attach bottom hooks.
Attach both bottom strap hooks (labeled BOTTOM).
Appropriate attachment points will depend on your
specific vehicle.
Acceptable attachment points may include the
bottom edge of the trunk, hatch lid, or rear door. Or
the tie down hooks underneath the vehicle. Or the
metal ledge of the bumper. Only attach hooks to
areas with sufficient support.
Route the straps over the KingJoe
Frame frame as shown.
WARNING: DO NOT ATTACH THE LOWER HOOKS TO GLASS, OR PLASTIC! USE THE GLASS HATCH
ADAPTERS. USE OF THE GLASS HATCH ADAPTERS WILL LIMIT THE LOAD TO TWO BIKES ONLY.
Attach side hooks.
Adjust straps as necessary to attach side
strap hooks (labeled SIDE) to upper side
edge of trunk, hatch, rear door, or above,
below, or next to the tail lights. Adjust
straps by pulling on free end of straps.
YES
NO!
Note: If it is difficult to
get the hook in, insert in
a wider section and then
slide into place.
TIGHTEN ALL STRAPS COMPLETELY. DO NOT OVERTIGHTEN.
1033584A-4/30
Follow Glass Hatch Adapter installation instructions on page 6.
NO!
YES

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kingjoe pro 3

Table des Matières