How To Use - HUROM H-AI Serie Manuel D'instructions

16

How to Use

Smart Hopper
1
Set the lever to [

extraction.
The chamber may not be assembled onto the
main body if the control lever is not in CLOSE

[ CLOSE] position.
2
Insert the prepared ingredients and close
the lid.
Assemble the mixing bar, prepare ingredients
according to their characteristics, and insert them
into the hopper.
Check the [MAX] and [
of the hopper and make sure the ingredients in the
hopper do not exceed that line.
 Putting an excessive amount of ingredients can
strain the juicer.
3
Turn the power dial to [ON] (clockwise).
For safety, the main body does not operate by
itself. It will only operate when it is properly
assembled with the chamber set.
4
Set the lever to Half Open [
ingredients go down through the chamber
set.
Set the lever to [ ] (Half Open) when all
◑
ingredients go down through the chamber set
and operate until no more pulp comes out of the
juicer.
5
After extraction, turn the power dial to [
(counterclockwise) to stop the juicer.
For performance and safety, the juicer will not
stop instantly but slow down to a stop when the
dial is turned.
Note
When turning the dial to [ON] or [REV], turn it only after
the screw stops completely.
CLOSE ] before
] icons on the side
] when all
◑
]