HUUM CLIFF Serie Notice De Montage Et D'utilisation page 9

First-time use of the sauna heater
Before switching the heater on, the insulation resistance might prove
to be lower than the standard. The reason for that is the moisture
seeped into the insulating layer during storage in the warehouse and
transportation.
The moisture evaporates in 1–2 hours of heating the electric heater.
Controlling the heater
All certified control panels may be used in controlling the heater.
The output of the heater must remain in the interval determined by
the control panel's producer.
Product can be used only with controlunit with timer function.
Including other than those for installation in public saunas, shall be
provided with a timer. For appliances for use in blocks of flats, hotels
and similar locations, the operating period of the sauna heater
shall be limited to 12 h with a minimum rest period of 6 h before any
automatic restarting. For other appliances, the operating period
of the timer shall be limited to 6 h, automatic restarting not being
allowed.
Guard rails
It is recommended to construct a guard rail around the heater.
•
We recommend using materials with low heat capacity and bad
thermal conductivity for the guard rail.
Upon using flammable materials, it is necessary to leave the
•
specified minimal safety clearances between the heater and
flammable constructions.
ATTENTION! IF THE HEATER IS INSTALLED CLOSER TO FLAMMABLE
CONSTRUCTIONS THAN AT THE DISTANCE OF THE MINIMAL REQUIRED
PROTECTION BELT IT MAY CAUSE A FIRE HAZARD!
9