Saw Chain Filing And File Gauges - Husqvarna 575XP AutoTune EPA I Manuel D'utilisation

RECOMMENDED CUTTING EQUIPMENT FOR CANADA
The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of powerhead,
bar and chain meet all requirements outlined in the CSA Z62.1-03 Chainsaws and Z62.3-96 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For
guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth
may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less
kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are
available at your dealer.
Length, inch Pitch, inch
16 3/8
18 3/8
20 3/8
24 3/8
28 3/8
16 3/8
18 3/8
20 3/8
24 3/8
28 3/8
Saw chain filing and file gauges
TECHNICAL DATA
Bar
Gauge, inch Max. nose radius
0,058
0,058
0,058
0,058
0,058
11T
0,050
0,050
0,050
0,050
0,050
Chain
Type Drive link count
60
68
Husqvarna H42,
72
Husqvarna H48
84
92
60
68
Husqvarna H46,
72
Husqvarna H47
84
93
English – 39