Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
S
Drill a 1/4" (6mm) mounting hole at
the mark on the floor, then drill two
1/4" (6mm) hanger bolt holes at the
marks on the wall.
S
Mount hanger bolts to the wall so
approximately 1-1/4" (3.2cm) of
each bolt remains exposed.
NOTE:
Other fastening devices of
sufficient size and strength may also be
used.
S
Install the faucet and drain to the
lavatory according to the
manufacturer's instructions.
NOTE:
Do not fully tighten slip-joint
drain connections at this time.
S
Position the pedestal mounting hole
over the hole in the floor.
S
Secure the pedestal to the floor with
the wood screw and washer. Tighten
the wood screw until it is snug.
CAUTION: Risk
of
.
damage
Do
not
Overtightening may cause damage to
the product.
S
Set the lavatory on the pedestal so
the hanger bolts extend through the
lavatory holes.
S
Level the lavatory.
S
Install the cap nuts and washers,
and tighten until snug.
CAUTION: Risk
of
.
damage
Do not overtighten the cap
nuts. Overtightening may cause
damage to the product.
S
Connect and tighten the trap.
Connect the hot and cold water
supplies to the faucet.
Kohler Co., Kohler, WI U.S.A.
Hanger
Bolts
product
overtighten.
Hanger
Bolts
product
Pedestal
3
Finish Wall
Wood
Screw
Pedestal
Washer
Finish Wall
Cap
Lavatory
Nut
Washer
A
1010419-2-
Publicité
Table des Matières
