Kimberly-Clark PROFESSIONAL ICON Mode D'emploi page 2

Install Dispenser Bracket Install Bracket
Enclosed**
For push buttons and other available parts,
contact your sales representative.
Mount the toilet paper dispensers
7 inches (180 mm) minimum and
9 inches (230 mm) maximum in front
of the toilet measured to the centerline
of the dispenser.
The bottom of the dispenser shall be
15 inches (380 mm) minimum and 48
inches (1220 mm) maximum above the
finished floor. For the ICON™ dispenser,
the center of the install bracket is the
center of the dispenser.
1. Align bracket to local ADA required*
distance from floor + 2 3/8" (6 cm).
This will ensure the bottom of the
dispenser is at the correct ADA required*
height. Make sure the built-in level on the
bracket reads level. Ensure the required
clearance space is free of obstructions
for proper dispenser installation.
2. Carefully brace the mounting bracket in
place once it is properly located on the
wall and mark holes to drill.
3. Remove the bracket from the wall,
leaving just the four marked holes. Drill a
hole in each of the four marked locations
so anchors can be inserted.
4. Tap in the four anchors** in each drilled
hole so the bracket can be screwed to
the wall.
** Ensure that proper mounting hardware
is used for appropriate wall composition
as enclosed hardware may not be
compatible with your wall surface.
Tools Required:
7" - 9"
1.
6 / " 16 cm
2"
5 cm 5 cm
2 ⁄ " 6 cm
ADA required height to floor
3.
*Check for regional & local installing/
mounting requirements.
2.
2"
4.