Table des Matières
Publicité
Step
Step 8
Carefully turn your unit over onto its front edges. Lay the
å
SMALL BACK (F) over your unit.
Make equal margins along all four edges of the SMALL
å
BACK (F). Push on opposite corners of your unit if needed
to make it "square".
Fasten the SMALL BACK (F) to the LARGE BACK (D). Use
å
four BLACK 9/16" LARGE HEAD SCREWS (CC)
Fasten the SMALL BACK (F) to your unit using the NAILS (MM).
å
NOTE: Be sure the notched edge of the SMALL BACK is
å
along the top edge of your unit.
Fasten the BASE (J) to the ENDS (A4 and B3). Use two
å
BLACK 9/16" LARGE HEAD SCREWS (CC) through the
ANGLE BRACKETS on the ENDS and into the BASE.
BLACK 9/16" LARGE HEAD SCREW
(6 used in this step)
www.sauder.com/services
A4
CC
Notch
CC
F
D
J
102702
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(10 used in this step)
B3
MM
NAIL
Page 13
Publicité
Table des Matières
