Replacing The Solenoid - NAMCO TIME CRISIS III SD Manuel De L'opérateur

6-5-4

Replacing the Solenoid

1. Remove the Gun Covers.
2. Disconnect the Solenoid Connector.
3. Remove 1off flange screw (M3x10) and remove the Solenoid Bracket.
4. Remove 1off flange screw (M3x8) and detach the earth wire.
5. Loosen the nut (16mm) and pull out the Solenoid.
6. Remove 2off flange screws (M4x6) and detach the Slide Guide.
7. Pull out the Solenoid Plunger, taking care not to lose the Spring.
Solenoid
Connector
Nut (16mm)
Solenoid
8. Reassemble in reverse order.
Note:
Spring Plunger
Earth wire Solenoid
bracket
Flange screw
(M3x8)
Toothed washer
Spacers
Slide guide
Solenoid bracket
E-type snap rings
Plunger
When reassembling match the D-type hole of the solenoid bracket to the
D shape of the solenoid and ensure that the 'E' ring and spacers are in
their correct positions.
Page 64
(see 6-5-3 page 63)
Flange screw
(M4x6)
Socket cap screw (M 3x10)
Slide guide
Harness outlet (it must
face downwards)
Gun cover L