Fitting The Header Assembly - NAMCO TIME CRISIS III SD Manuel De L'opérateur

4-2

Fitting the Header Assembly

l l l l l
The Header Assembly has a forward centre of gravity, so it is important that
at least two people are used to fit or remove the Header Assembly.
l l l l l
The fitting position of the Header Assembly is high, and it is important that
a means of reaching the height safely, without stretching, is available. (e.g.
Steps, Step Stool etc.)
1. Place the Header Assembly on to the Monitor Cabinet and connect the
connector.
2. Slide the Header Assy backwards ensuring that the Retaining Brackets on the
Header Assy engage in the holes on the top of the cabinet,.
Connectors
3. Fit 2off security screw (M5x12) to retain the Header Assy to the Monitor Cabinet.
Retaining
Brackets
Security screw
(M5x12)
Page 37
Header
Assembly