Maytag MAV-39 Guide De L'utilisateur page 11

Fills with the Wrong Temperature Water
• Turn both faucets on fully.
• Make sure temperature selection is correct.
• If Auto Temperature Control is selected, cold water may feel warmer than cold water from the tap (see page 3).
• Make sure hoses are connected to correct faucets and inlet connections. Be sure water supply is regulated correctly.
Flush water line before filling washer.
• Check the water heater. It should be set to deliver a minimum 120° F (49° C) hot water at the tap. Also check water
heater capacity and recovery rate.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• To obtain the energy savings, warm water fills are lukewarm.
• To save energy, this washer will regulate wash water temperatures by mixing hot and cold water to reach the
proper water temperature.
Cycle Selector Advances Through Off
• Extra rinse is selected.
Finger Faucet Will Not Operate
• The water level switch has detected a full tub. No more water will be added to prevent the tub from overflowing.
For further assistance contact Maytag Services
U.S. customers using TTY for deaf, hearing impaired or speech impaired, call 1-800-688-2080.
NOTE: In our continuing effort to improve the quality of our appliances, it may be necessary to make changes to
the appliance without revising this guide.
(select models)
U.S. 1-800-688-9900 or Canada 1-800-688-2002
SM , Maytag Customer Assistance:
10